Installation Guide

Faucet Installation
2
Installation Guide
A.
C.
E.
G.
B.
D.
F.
H.
Turn off the water supply. Remove the faucet
with the mounting hardware attached from the
package.
Insert the shank of the faucet body into the hole
of the sink deck. If installing a base plate, insert
the faucet shank through the base plate rst
followed by the base plate gasket, and then into
the holes of the sink deck.
Hand-tighten the lock nut until secure. Then, use
a screwdriver to tighten each screw slightly until
all are secure.
Install the weights onto the hose using two
screws. Position the weights two feet from the
underside of the sink deck. Use a screwdriver
to tighten the screws securely.
Remove all mounting hardware from the shank.
From the underside of the sink or mounting
surface, attach the washer, followed by the lock
nut, and screws onto the shank.
Plug the spray hose into the quick connect at the
base of the copper tube.
Connect 3/8" compression ttings to each
hose, and then to each corresponding water
supply line. Secure each tting with a 1/4 turn
of a wrench.
A
C
E
G
D
F
H
B
shank
1
2
Water supply
Connector
sink deck