Installation Guide

Important
Faucet Installation Continued
3
Installation Guide
1. Be sure to correctly identify the hot/cold water supply pipes before installing the valves.
2. The torque suggested: 100-120 kg/cm (for models 717 and 750)
3. The suggested hot/cold water supply temperatures are:
Hot water supply 49C (120F)- 82C (180F)
Cold water supply 4C (39F)- 29C (85F)
4. When assembly is completed, test the xture to be sure the water temperature ow
matches the handle position indicated. (Hot position provides hot water. Cold position
provides cold water.)
5. The temperature valve should be set by a professional installer. Improper installation could
cause excessive temperatures and injury.
6. Connect spout and shower unit. Attach shower
head ONLY after ushing the system with both
hot and cold water for 1 minute.
After all connections have been made,
attach handle and test the system. Check all
connections and valve for any leaks.
Test water pressure on full hot and cold. If water
pressure is unbalanced, use the stud on the valve
to adjust.
Do not insert the screens
washer into the inlet
4"
1/2"
2"
66"
4"
1/2-14NPT"
Min 24"
Open
Close Down
Cold
Hot
Up
Floor level
5 1/2"
14 1/2"
8"
Insert the screen washer