Installation Guide

ManualsBrandsSir Faucet ManualsKitchenChrome 2-Handle Deck-Mount Low-Arc Handle Kitchen Faucet

Tools

Certifications & Information

Conguration

Connect to water supply lines with TWO

3/8" Compression Faucet Connectors

Three-hole Installation

24" MAX Centerset

Four-hole Installation with available side spray

GPM

Flow Rate Chart

PSI

10 20 30 40 50 60 70 80

2.5

1.5

Faucet

Sir

Water supply

Connector

1Installation Guide

• ADA Approved

• Limited Lifetime Warranty

Model 744

Double Handle Faucet with Optional Side Spray

Installation Guide

24" MAX

1 1/16"

1 1/4"

Gather the necessary tools as shown to complete the installation of this faucet.

Adjustable Wrench

Phillips Screwdriver

The following tools are optional:

FlashlightSafety Glasses Channel Lock

Pliers

Summary of content (4 pages)

PAGE 1
Installation Guide Model 744 Double Handle Faucet with Optional Side Spray Certifications & Information • • ADA Approved Limited Lifetime Warranty GPM Flow Rate Chart 3 2.5 2 1.5 0 0 10 20 30 40 50 60 70 80 PSI Tools Gather the necessary tools as shown to complete the installation of this faucet.
PAGE 2
Installation Guide Faucet Installation A. Turn off the water supply. Remove the faucet with the mounting hardware attatched from the package. A B lock nut *An optional matching side spray is also available. B. Remove all mounting hardware from the faucet handle shanks. washer shank quick connect *Coupling nut and cone washer are optional for this installation depending on your waterline connection. C. Insert the shank of the faucet handle body into the hole of the sink deck.
PAGE 3
Installation Guide Faucet Installation Continued G. (1) Tighten the tee fitting on to faucet shank (2) Attach the hot and cold supply lines to the Tee fitting at the faucet base. G (3) Attach the opposite end of each hose to the corresponding quick connect fittings by tightening the 3/8” compression fittings onto the lines. Secure all fittings with a 1/4 turn of a wrench. 1 3 2 (4) Secure water line connections to each corresponding faucet handle shank base.
PAGE 4
www.mrdirectint.com sales@mrdirectint.com 1-877-946-5725 Important Turn on the water supply SLOWLY, to test for leaks before completely opening the water lines. Remove the aerator from the end of the faucet by carefully unscrewing it. Let hot and cold water run through both water lines for at least one minute before replacing the aerator. This will help to clear any debris in the line, which could otherwise clog the system.