Installation Guide

Faucet Installation
E
C
F
A
A. Turn off the water supply. Remove the
faucet and faucet handles with the mounting
hardware attached from the package.
B. Insert a phillips head screw driver into the
faucet handle body removing the set screw.
Separating the valve body from the handle
body.
D
B
C. From the underside of the sink or
mounting surface, attach the gasket and
washer, followed by the lock nut, onto
the shank. Insert the shank of the faucet
handle body into the hole of the sink
deck.
D. Lower the faucet base into the mounting
surface followed by the faucet handle.
Using a phillips screw drive tighten the
set screw until secure. Replace the
handle cover.
Repeat the above steps for the second
faucet handle.
E. Remove all mounting hardware from the
faucet shank. Lower the faucet shank into
the mounting surface.
F. From the underside of the sink or mounting
surface, attach the washer, followed by the
lock nut, onto the shank. Tighten the lock
nut until secure.
2
Installation Guide
shank
set screw
handle body
lock nut
handle
cover
faucet base
valve body
handle base