Installation Guide

Remove the aerator from the end of the faucet by carefully unscrewing it.
Let hot and cold water run through both water lines for at least one minute before
replacing the aerator. This will help to clear any debris in the line,
which could otherwise clog the system.
Important
Faucet Installation Continued
G
To prevent damage to the tube body, tighten the connections by carefully using two
wrenches as shown. Use caution to not bend the stem.
Check for leaks.
Turn on the water supply SLOWLY, to test for leaks
before completely opening the water lines.
H. Attach the opposite end of each hose
to the corresponding water supply lines
by tightening the 3/8" compression ttings
onto the lines. Secure all ttings with a 1/4
turn of a wrench.
3
Installation Guide
H
G. Tighten screws to secure faucet using a
phillips head screwdriver.