Installation Guide

Insert the screen
washer
Important
Faucet Installation Continued
3
Installation Guide
6. Connect spout and shower unit. Attach shower head
ONLY after ushing the system with both hot and
cold water for 1 minute.
After all connections have been made, attach handle
and test the system. Check all connections and valve
for any leaks.
Test water pressure on full hot and cold. If water
pressure is unbalanced, use the stud on the valve to
adjust.
Do not insert the screen
washer into the inlet
1. Be sure to correctly identify the hot/cold water supply pipes before installing the valves.
2. The torque suggested: 100-120 kg/cm (for models 717 and 750)
3. The suggested hot/cold water supply temperatures are:
Hot water supply 49C (120F)- 82C (180F)
Cold water supply 4C (39F)- 29C (85F)
4. When assembly is completed, test the xture to be sure the water temperature ow
matches the handle position indicated. (Hot position provides hot water. Cold position
provides cold water.)
5. The temperature valve should be set by a professional installer. Improper installation could
cause excessive temperatures and injury.
4"
2"
66"
4"
1/2-14NPT"
Min 24"
Open
Close
Down
Cold
Hot
Up
Floor level