Installation Guide

ManualsBrandsSir Faucet ManualsBath2-Spray 3.3 in. Single Wall Mount Fixed Shower Head in Brushed Nickel

Model 717

3 Piece Tub & Shower Set

Tools

Certifications & Information

Determining Your Existing Rough-in Plumbing Installation

Installation Guide

Gather the necessary tools as shown to complete the installation of this faucet.

The following tools are optional:

1Installation Guide

• ADA Approved

• Limited Lifetime Warranty

If you are replacing your plumbing valve, see below for common plumbing methods. Specic rough-in

ttings are not supplied, but may be required for installation.

IPS SWEAT

FlashlightSafety Glasses Channel Lock Pliers Adjustable

Wrench

Thread seal tape Pipe Wrench Piping 7/32” Hex

Wrench

Screwdriver

Set

GPM

Flow Rate Chart

PSI

10 20 30 40 50 60 70 80

2.5

1.5

DOWN

Summary of content (4 pages)

PAGE 1
Installation Guide Model 717 3 Piece Tub & Shower Set Certifications & Information • • GPM ADA Approved Limited Lifetime Warranty Flow Rate Chart 3 2.5 2 1.5 Tools 0 0 10 20 30 40 50 60 70 80 PSI Gather the necessary tools as shown to complete the installation of this faucet.
PAGE 2
Installation Guide Faucet Installation 1. Before soldering, remove ceramic cartridge & pressure balanced valve (1, 2, 3, 4, 5, 6). Then remove integral (7, 8, 9, 10, 11, 12, 13) from shower body. 2. After cool down from soldering, replace the integral (7,8,9,10,11,12,13) in reverse order back to shower body. Use a flat head screwdriver to turn the studs (9) to the “Close” position. DO NOT install pressure balanced valve and ceramic cartridge. Turn on water supply. Check connection for leak.
PAGE 3
Installation Guide Faucet Installation Continued 6. Connect spout and shower unit. Attach shower head ONLY after flushing the system with both hot and cold water for 1 minute. Insert the screen washer 1/2-14NPT" Test water pressure on full hot and cold. If water pressure is unbalanced, use the stud on the valve to adjust. 2" Min 24" Do not insert the screen washer into the inlet Up Hot Open 4" 66" After all connections have been made, attach handle and test the system.
PAGE 4
www.mrdirectint.com sales@mrdirectint.com 1-877-946-5725 Maintenance & Cleaning The faucet can be cleaned by rinsing with clear water or washing with mild detergents. Dry the faucet with a clean, soft cotton cloth. CAUTION: do not use any cleaning agents containing acids, abrasives, or other harsh chemicals. Simply rinse and dry faucets with a soft towel every week to prevent mineral deposits from forming. Clean spills and splatters as they happen.