Installation Guide

ManualsBrandsSir Faucet ManualsKitchenBrushed Nickel 2-Handle Deck-Mount Pull-Out Handle Kitchen Faucet

Tools

Certifications & Information

Conguration

Connect to water supply lines with TWO

3/8" Compression Faucet Connectors

Three-hole Installation

8" Centerset

Four-hole Installation with available side spray

GPM

Flow Rate Chart

PSI

10 20 30 40 50 60 70 80

2.5

1.5

Faucet

Sir

Water supply

Connector

1Installation Guide

Model 7142

Double Handle Faucet with Optional Side Spray

Installation Guide

Gather the necessary tools as shown to complete the installation of this faucet.

Adjustable Wrench

Phillips Screwdriver

The following tools are optional:

FlashlightSafety Glasses Channel Lock

Pliers

Faucet

Sir

8" 4"

• NSF Certified

• cUPC & UPC

• ADA Approved

• Limited Lifetime Warranty

• Lead Free Construction

Summary of content (4 pages)

PAGE 1
Installation Guide Model 7142 Double Handle Faucet with Optional Side Spray Certifications & Information • • • • NSF Certified cUPC & UPC ADA Approved Limited Lifetime Warranty • GPM Lead Free Construction Flow Rate Chart 3 2.5 2 1.5 0 0 10 20 30 40 50 60 70 80 PSI Tools Gather the necessary tools as shown to complete the installation of this faucet.
PAGE 2
Installation Guide Faucet Installation A. Turn off the water supply. Remove the faucet with the mounting hardware attatched from the package. A B B. Remove all mounting hardware from the shanks. *Coupling nut and cone washer are optional for this installation depending on your waterline connection. shank washer lock nut *cone washer *coupling nut C D E F C. Insert the shanks of the faucet body into the holes of the sink deck. D.
PAGE 3
Installation Guide Side Spray Installation Replacing plug with supplied Quick Connect connection. 1 Side Spray Installation A. Insert spray hose assembly (1) to far right hole on the sink, hand tighten with lock nut from underneath. 3 B. Insert spray hose (2) down hose assembly. C. Connect male end (3) with spray and hand tighten. 2 Assembly E. Clean installation site, remove debris from the area. F. Remove mounting nuts (4) and nut gasket (5) while keeping gasket (6) attached. 6 5 4 7 8 G.
PAGE 4
www.mrdirectint.com sales@mrdirectint.com 1-877-946-5725 Important Turn on the water supply SLOWLY, to test for leaks before completely opening the water lines. Remove the aerator from the end of the faucet by carefully unscrewing it. Let hot and cold water run through both water lines for at least one minute before replacing the aerator. This will help to clear any debris in the line, which could otherwise clog the system.