Installation Guide

Faucet Installation
E
C
F
A
A. Turn off the water supply. Remove the
faucet with the mounting hardware
attatched from the package.
B. Remove all mounting hardware from
the shanks.
D
B
C. Insert the shank of the faucet body into the
hole of the sink deck. If installing a base plate,
insert the faucet shank through the base
plate rst, followed by the faucet gasket, and
then into the holes of the sink deck.
D. From the underside of the sink or mounting
surface, attach the washer, followed by the
lock nut, and screws onto the shank.
E. Hand-tighten the lock nut until secure.
F. Then, use a screwdriver to tighten each screw
slightly until all are secure.
2
Installation Guide
shank
washer
lock nut
gasket