Installation Guide

A.
C.
E.
B.
D.
F.
Turn off the water supply. Remove the faucet
with the mounting hardware attached from the
package.
Insert the shank of the faucet body into the hole
of the sink deck. If installing a base plate, insert
the faucet shank through the base plate rst, and
then into the holes of the sink deck.
Hand-tighten the lock nut until secure. Then, use
a screwdriver to tighten each screw slightly until
all are secure.
Remove all mounting hardware from the shank.
From the underside of the sink or mounting
surface, attach the washer, followed by the lock
nut, and screws onto the shank.
Connect 3/8" compression ttings to each hose,
and then to each corresponding water supply
line. Secure each tting with a 1/4 turn of a
wrench.
Faucet Installation
A
C
E
D
F
B
2
Installation Guide
shank
1
2
Water supply
Connector
sink deck