Installation Guide

ManualsBrandsSir Faucet ManualsKitchenChrome 1-Handle Deck-Mount High-Arc Handle Kitchen Faucet

Tools

Certifications & Information

Configuration

Gather the necessary tools as shown to complete the installation of this faucet.

Connect to water supply lines with TWO

3/8" Compression Faucet Connectors

The following tools are optional:

Four-hole Installation

Adjustable Wrench

GPM

Flow Rate Chart

PSI

10 20 30 40 50 60 70 80

2.5

1.5

Faucet

Sir

Water supply

Connector

1Installation Guide

Flashlight

Safety Glasses

Channel Lock

Pliers

Phillips screwdriver

Model 710

Four-Hole Kitchen Faucet

Installation Guide

• NSF Certified

• cUPC & UPC

• ADA Approved

• Limited Lifetime Warranty

• Lead Free Construction

1 1/4"

1 3/8"

9" MAX 9" MAX 9" MAX

Summary of content (4 pages)

PAGE 1
Installation Guide Model 710 Four-Hole Kitchen Faucet Certifications & Information • • • • GPM NSF Certified cUPC & UPC ADA Approved Limited Lifetime Warranty • Lead Free Construction Flow Rate Chart 3 2.5 2 1.5 0 0 10 20 30 40 50 60 70 80 PSI Tools Gather the necessary tools as shown to complete the installation of this faucet.
PAGE 2
Installation Guide Faucet Installation A. Turn off the water supply. Remove the mounting hardware from the remote valve shank. A B B. From the underside of the sink or mounting surface, attach the gasket and washer, followed by the lock nut, onto the shank. shank Tighten mounting screws until secure. mounting screws gasket washer lock nut C. Insert the shank of the faucet into the hole of the sink deck.
PAGE 3
Installation Guide Faucet Installation Continued G. Insert the side spray hose into the sink hole. From under the sink, securely hand tighten the lock nut. G H I J H. Attach side spray hose to the quick connect fitting at faucet base. I. Remove all mounting hardware from soap dispenser. Position the soap dispenser in desired mounting hole. J. From underneath the sink thread the nut onto the shank. Tighten the nut until the soap dispenser is firmly held in place.
PAGE 4
www.mrdirectint.com sales@mrdirectint.com 1-877-946-5725 Important Turn on the water supply SLOWLY, to test for leaks before completely opening the water lines. Remove the aerator from the end of the faucet by carefully unscrewing it. Let hot and cold water run through both water lines for at least one minute before replacing the aerator. This will help to clear any debris in the line, which could otherwise clog the system.