Installation Guide

Faucet Installation
2
Installation Guide
E
C
F
A
A. Turn off the water supply. Remove the
faucet with the mounting hardware
attatched from the package.
B. Remove all mounting hardware from
the shanks.
D
B
C. Insert the shanks of the faucet body into
the holes of the sink deck.
D. From the underside of the sink or
mounting surface, attach the washer,
followed by the lock nut, onto the shank.
Repeat this for the second shank.
E. Hand-tighten the lock nut until secure.
F. Attach a 3/8" compression faucet
connector to the end of each shank.
shank
washer
lock nut
*coupling nut
*cone washer
*Coupling nut and cone washer are optional for this
installation depending on your waterline connection.
G
G. Attach the opposite end of each hose
to the corresponding water supply lines
by tightening the 3/8" compression ttings
onto the lines. Secure all ttings with a 1/4
turn of a wrench.