User Guide

22
PARTS LIST - 09289 FIREBALL 1030
Ref. No. Description Sip Part No.
1. Front grill PW09-10339
2. Casing PW09-10340
3. Handle PW09-10341
4. Chamber PW09-10342
5. Chamber bracket PW09-10343
6. Terminal block PW09-10344
7. Burner assembly PW09-10345
8. Thermocouple PW09-10318
9. Thermostat PW09-10346
10. Electrode PW09-10336
11. Fan PW09-10347
12. Motor PW09-10348
13. Rear grill PW09-10349
14. Burner support PW09-10350
15. Capacitor 2mf PW09-10351
16-1. Gas valve PW09-10331
16-2. Solenoid valve PW09-10332
16-3. Gas pipe PW09-10352
16-4. Gas nozzle PW09-10353
17. Mains lead PW09-10323
18. Base PW09-10354
19. Plastic cover PW09-10326
20. Switch PW09-10329
21. Piezo ignitor PW09-10330
22. Regulator c/w hose PW09-10325
23. Bracket PW09-10335
24. Electrode PW09-10336
7
ELECTRICAL CONNECTION
Warning: Never connect live or neutral wires to the earth terminal of the
plug. Only fit an approved plug with the correct rated fuse. If in doubt
consult a qualified electrician.
This heater is fitted with a standard UK type 230v ~ plug. Before using the heater in-
spect the cable and plug to ensure that neither are damaged. If any damage is visi-
ble have the heater inspected / repaired by a suitably qualified person. If it is neces-
sary to replace the plug a heavy duty impact resistant plug would be preferable.
The wires for the plug are coloured in the following way:
Yellow / green Earth
Blue Neutral
Brown Live
As the colours of the wires may not correspond with the markings in your plug, pro-
ceed as follows: The wire which is coloured blue, must be connected to the terminal
marked with N or coloured black. The wire which is coloured brown, must be connect-
ed to the terminal, which is marked L or coloured red. The wire which is coloured yel-
low / green should be connected to the terminal which is coloured the same or
marked.
Always secure the wires in the plug terminal carefully and tightly.
Secure the cable in the cord grip carefully.
Cord Grip
WARNING! It is the responsibility of the owner and the operator to read, understand
and comply with the following:
You must check all electrical products, before use, to ensure that they are safe.
You must inspect power cables, plugs, sockets and any other connectors for wear or
damage.
You must ensure that the risk of electric shock is minimised by the installation of appro-
priate safety devices; A residual current circuit Breaker (RCCB) should be incorporated
in the main distribution board. We also recommend that a residual current Device
(RCD) is used. It is particularly important to use an RCD with portable products that are
plugged into a supply which is not protected by an RCCB. If in any doubt consult a
qualified electrician.