Instruction Manual

 Unscrew the slide lock (26).

 Pull on the release knob (6), raise the saw arm to its highest position and slide (pull) it

towards you.

 Loosen the mitre lock (12).

 Rotate the mitre table until the pointer aligns with the desired angle.

 Retighten the mitre lock (12).

 Place the workpiece flat on the table with one edge securely against the fence (9).

 Hold the operating handle (3) firmly and slide the safety switch to the left then

squeeze the trigger switch (4) (see below); allow the blade to reach maximum

speed.

Note: It is possible to remove the clamp assembly (18) by loosening the

clamp assembly lock and moving it to the other side of the table. Make

sure the clamp assembly lock is tight before using the clamp.

Note: When cutting long pieces of timber, support the opposite end of the

timber with the side support bars (11), a roller stand or a work surface that

is level with the saw table.

OPERATING INSTRUCTIONS….cont

CROSS-CUTTING (WITH SLIDE ACTION)

 Slowly lower the blade into and through the workpiece.

 Release the switch trigger (4) and allow the saw blade to stop rotating before raising

the blade away from the workpiece.

 Ensure that the blade has stopped and that the saw head is returned to a position

so that the guard is covering the blade before removing the workpiece.

SAFETY INSTRUCTIONS….cont

at the operator.

 Always remember to switch off the laser on / off switch (2) after finishing a job, only

turn the laser beam on when the workpiece is on the mitre saw table.

Caution: The warnings and cautions mentioned in this user manual can not cover all possible

conditions and situations that may occur. It must be understood by the operator that common

sense and caution are factors which cannot be built into this product, but must be applied.

This mitre saw is double insulated; This means the operator is sepa-

rated from the tool's electrical system by two complete sets of

electrical insulation. This extra layer of insulation is intended to pro-

tect the user from electrical shock due to a break in the wiring

insulation. All exposed metal parts are isolated from the internal

metal motor components with protecting insulation. Double insu-

lated tools do not need to be grounded (earthed). Servicing of a

tool with double insulation requires extreme care and knowledge

of the system and should be performed only by a suitably qualified

person.

Some wood and wood composites have the potential to be highly toxic;

always wear a face mask when operating saw.

When using the saw always ensure the operator as well as those in the

area wear eye protection.

When using the saw always ensure the operator as well as those in the

area wear ear protection.