Instruction Manual
22
As well as oiling the moving parts regularly, the grease in the gearbox will require re-
placement after extensive use of the saw. Refer to an authorised service agent to pro-
vide this service.
Cleaning and maintenance of this saw is mainly common sense some points for
guidance are as follows:
Regularly check that all the fixing screws are tight, particularly the outer flange. They
may vibrate loose over time.
The mains lead of the saw and any extension cord used should be checked fre-
quently for damage. If damaged, have the mains lead replaced by an authorised
service facility. Replace the extension cord if necessary.
Keep the air vents of the saw clear at all times.
After each use brush off any wood chippings with a soft brush. Pay special attention
to the inside of the dust extraction port (where the dust bag fits to the saw) as this is
where there will be a large build up if left for extended periods.
The motor of the saw should be cleared of any wood chippings as there would be
a risk of fire if they are allowed to build up over time (a soft brush or dry air could be
used to clear the motor).
Empty the bag at least after each use; the bag should be emptied before it gets
half full to ensure its efficiency. There is a zip on the bag to allow for easy disposal of
wood chippings.
Ensure the blade guard is kept clean with a damp cloth (do not clean the guard or
any part of the saw with a corrosive solvent) to reduce the risk of injury. Periodically
oil all the moving parts on the saw to extend the life of the saw.
Inspect the carbon brushes (in the motor) at frequent intervals (depending on the
amount of use) and change them if the wear reaches the worn limit line or is below
10mm, they should also be checked to ensure that the brushes move in and out
easily.
LUBRICATION
GENERAL INSPECTION
Caution: Water must never come into contact with the saw.
MAINTENANCE….cont
3
CONTENTS
Page No. Description
4. Safety Symbols Used Throughout This Manual
4. Safety Instructions
10. Technical Specifications
13. Electrical Connection
12. Guarantee
12. Contents and Accessories
13. Getting to Know Your Inverter Saw
15. Operating Instructions
20. Maintenance
2 &
23.
UK & EU -
Declaration of Conformity