Instruction Manual

GETTING TO KNOW YOUR SAW….cont

Ref. No. Description Ref. No. Description

1. Dust Collection Bag 16. Bevel Angle Scale

2. Carrying Handle 17. Workbench Mounting Hole

3. Operating Handle 18. Workpiece Clamp

4. On/Off Trigger Switch 19. Depth Stop

5. Motor 20. Mains Lead

6. Upper Blade Guard 21. Sliding Rail

7. Lower Blade Guard 22. Depth Stop Adjuster

8. Laser 23. Spindle Lock

9. Rear Fence 24. Laser On/Off Switch

10. Rear Fence Extension 25. Saw Head Release / Lock

11. Adjustable Side Support Rail 26. Sliding Rail Lock

12. Mitre Angle Lock 27. Fence Extension Lock

13. Mitre Angle Pointer 28. Side Rail Lock

14. Mitre Angle Scale 29. Bevel Angle Lock

15. Bevel Angle Pointer 30. Bevel Stop

This saw is fitted with a standard UK type 230v ~ plug. Before using the tool inspect the

cable and plug to ensure that neither are damaged. If any damage is visible have

the tool inspected / repaired by a suitably qualified person. If it is necessary to replace

the plug a heavy duty impact resistant plug would be preferable.

The wires for the plug are coloured in the following way:

Blue Neutral

Brown Live

As the colours of the wires may not correspond with the markings in your plug, pro-

ceed as follows:

 The wire which is coloured blue, must be connected to the terminal marked with N

or coloured black.

 The wire which is coloured brown, must be connected to the terminal, which is

marked L or coloured red.

 Always secure the wires in the plug terminal carefully and tightly. Secure the cable in

the cord grip carefully.

This mitre saw is double insulated. This means the operator is separated

from the tool's electrical system by two complete sets of electrical insula-

tion.

ELECTRICAL CONNECTION

Warning: Never connect live or neutral wires to the earth terminal of the plug.

Only fit an approved plug with the correct rated fuse. If in doubt consult a quali-

fied electrician.

Note: Always make sure the mains supply is of the correct voltage and the

correct fuse protection is used. In the event of replacing the fuse always

replace the fuse with the same value as the original.

Note: If an extension lead is required in order to reach the mains supply;

ensure that this too is rated for the correct voltage and fuse rating.

Note: The cross section of the extension lead should be checked so that it

is of sufficient size so as to reduce the chances of voltage drops.