User manual
5
Contens
e fanfare is type-tested according to ECE regulation, registration free, and approved in trac.
e Sinustec BigBlast Fanfare Set, with the Item number:13958 is only suitable for 12V.
e Sinustec BigBlast Fanfare Set, with the Item number:13959 is only suitable for 24V.
Safety instructions
Make sure for problem-free tting, read these instalation and operating instructions carefully befor starting work.
When changing the owner the insatllation and operationg instruction must be presented.
Because of the risk of short circuits, always disconect the negativ pole of the battery before starting work. At vehicles
with a second battery, you must also disconnect this negativ pole. When disconnecting the negative terminal of the
battery will lose all memory of the volatile electronics comfort their stored data.
Working on electrical systems in vehicles should only be carried suitably qualied personnel!
For installation you have to observe all safety regulations
When you install the compressor, make sure that the hoses are as straight as possible and not bent. Make sure that there
is no dirty particles stuck in the tubes, if you connect the hoses to the compressor.
Make sure that all bolts and nuts are tightened, so that they can not solve while driving.
When you drill two holes, for mounting the 2 compressor fanfare, in the vehicle structur, make sure that the surface of
the vehicle will be not damaged ( for example corrosion). Be careful when drilling that you don´t drill into any cable or
supporting parts.
Check all the mounting points of the device periodically by that a proper operation and a tight t be ensure in the
vehicle.
Delivery
5 Safty instruction
5 Delivery
6 Installation
6 Wiring diagram
6 Technical data
1. 1x Compressor
2. 1x Horn (38cm/33cm)
3. 1x Horn relay
4. 1x Rubeer bottom cushion
5. 1x Y-air splitter
6. 6x Small at washer Ø 6
7. 1x Big at washer Ø 8
8. 3x Bolt 6x25
9. 1x Bolt 8x20
10. 3x Nut M6
11. 1x Nut M8
12. 1,5m Rubber hose
13. 6x Circle hose clip
! !
!
!
!
!
!
!