Operation Manual

Cycle Safety
27
NOTE
Incorrect use of bike carriers.
Risk of damage!
x Only use approved bike carriers that allow the cycle to be
transported upright.
x Consult a dealer about a suitable carrier system.
x Cycles with hydraulic disc or rim brakes must never be
transported upside down on their saddles. This may cause
the hydraulic disc or rim brakes to fail.
x Secure the cycle so that it cannot slip or fall off.
Dealers offer a variety of carrier systems for transporting the cycle by car.
x Consult your dealer about suitable carrier and fastening systems.
x Refer to and follow national and regional road regulations.
x Refer to the information enclosed by the manufacturer about fitting and use.
x In the case of carbon-component cycles, note that these components can be
damaged by clamping forces. Only use dedicated fastening systems.
x Note the change in the height of your car when using a roof carrier system.
Measure the exact height before driving off.
x Fit the transport locks on disc brakes when you transport the cycle without wheels.
x When transporting pedelecs or S-pedelecs, follow the instructions in the original
operating manual for the drive system.
3.5 Notes on torques
WARNING
Material fatigue due to tightening screw joints incorrectly.
Risk of accident and injury!
x Do not use the cycle if you find loose screw joints.
x Screw joints must be properly tightened with a torque wrench.
x Screw joints must be tightened using the correct torques.