Installation Guide

2
1
Remove the
shipping plate.
Unscrew the 2 screws
using a square / flat
screwdriver.
Separate the 2 parts
of the monitor.
Install the batteries in the top
part of the monitor.
Note: Install batteries as
marked on the battery
housing compartment.
3
4
LM4110-ZB
Installation Guide
Tank Monitor
INSTALLING THE BATTERIES AND ACTIVATING THE MONITOR
MONITOR ACTIVATION (CONT'D)
MONITOR ACTIVATION
IMPORTANT
Tanks that do not have R3D gauges
can be upgraded. Contact your
propane supplier for details.
WARNING
The installation of the batteries must be performed at a minimum
distance of 3 meters (10 feet) from the propane tank.
Propane tank
Pre-installed R3D
tank gauge
Rochester Gaugess
Model Part number
R3D-LP 5-95% 5909S02733
R3D-LP 10-80% 5909S02772
Fuel tank
FLRG-48 gauge
Sinopé
FLRG-48
YOUR TANK MONITOR
MATERIALS REQUIRED
FOR INSTALLATION
Antenna
Magnetic sensor
(Hall effect)
Base
The monitor can be installed using the magnetic base on
several places on the tank. However, it must be cleared from
the wall. Also position it so that the filling valve is free.
INSTALLATION OF THE MONITOR ON THE TANK
Insert the remote sensor into the R3D
remote-ready dial until it snaps into
place. Make sure the dial is clean
before installing the remote sensor.
The tank monitor can also be attached
with screws (not included) or with
plastic cable ties.
The tank monitor should be installed away from metal surfaces
(aluminum or steel coatings, aluminum railing).
Horizontal
tank
Vertical
tank
Tap , then select "Add Device".
2
1
If you do not have an
account yet, download the
Neviweb app for iOS or
Android to create an
account and add your
device.
Get the app
Follow the steps of the installation wizard.
3
Put the top part of the monitor back on the
base and tighten firmly (9 lbs-ft or 12.2 Nm
torque required) to make sure the monitor
is waterproof.
4