User Manual

d. Direction Button: Press the direction buttons for selection.
e. OK Button: Confirm the selection. During digital zooming,
press this button would restore the default view.
f. : Mute Button, press the turn on or off the microphone.
g. : Return Button: Press to return to previous menu or
quit an app.
h. : Menu Button, press to invoke the menu in different
interfaces.
i. Number keys and : Number Buttons, press to input the
numerals.
j. : # & Auto Framing Button, press to type in “#”.
In the video conference interface or when the camera is
turned on, press and hold to enable/disable the auto framing
feature. (" " means open, " " Means off.)
Presets:
1) In the video conference interface or when the camera is
turned on, can set and switch the presets in settings.
(Available only when auto framing is disabled).
2) Press and hold the number button "1/2/3" for 2 seconds
to save the current view as a preset.
3) Each preset may including zooming level, viewing angle
information. Up to three presets are supported.
4) Press 1/2/3 to switch amongst the presets. ฀
Romote Control
b
h
b
d
d
a
c
f
d
d
e
g
i
j
c
a. ：Power Button, press to start the power off
countdown. Press and hold for 2 seconds to power off.
b. : Volume Button, press to adjust the system volume.
c. : Digital Zooming,press to digitally zoom the camera.
(Available only when auto framing is disabled.) After zooming
in, the direction button may move the camera image.
3. Quick Start
1) Please use HDMI cable to connect this product to the
monitor.
2) To turn on the device, press the power button on the back
of the product or use remote control.
3) After successful startup, the product functions can be used.
Accessories introduction
Please check the following items in the product box.
HDMI cable x1 Wall-mounted components x1
Peeping cover x1 Power adapter×1
Battery×2 Remote control x1
User manual x1 *USB cable×1
Note: * neans that some accessories are optional.
FCC WARNING
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation.If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician
for help.
FCC RF warning statement:
This equipment must be installed and operated in accordance
with provided instructions and the antenna(s) used for
this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna
or transmitter. End-users and installers must be provide
with antenna installation instructions and transmitter
operating conditions for satisfying RF exposure compliance.