User's Manual

User Manual for ANC Wireless Earbuds
Model:ANC008S
Please carefully read this Manual before using this product for
the very first time and well keep it for the further reference.
Ⅰ. Product Overview
1. Introduction:
The ANC008S combines active noise cancelling and TWS Bluetooth
technique, supports two-way calls and saying “hey siri” to wake up Siri in
IOS system . This noise reduction wireless earbuds is charging with a
charging compartment (charging case), and also supports the QI standard
of wireless charging.
2. Specification:
Bluetooth
Communication Scope
Frequency Response
Sensitivity/Impedance
Support
Battery Capacity
Horn
Play/Talking Time
ANC on Time
Maximum Noise Cancellation
Charging Box Charging Port
Product Size(charging box)
Product Weight
V5.0
≤10m(no obstacle)
20Hz-20kHz
117dB±3dB/28Ω
HFP/HSP/A2DP/AVRCP
300mAh/35mAh
12mm Moving Coil Unit
4.2H/4.0H
3.5H
35dB
Lightning Port
60*45*21.7mm
About 46.5g
Chip/Audio Coding
AIROHA AB1536/SBC/ACC
Waterproof Level
IPX4
1
Ⅱ. Schematic Diagram
1
2
3
4
1
Touch sensing area
3
Function keys
2
Charging interface
4
Position oncharging pad
2
Ⅲ. Function Overview
Bluetooth Pairing:
1. Enter the phone settings, turn on the Bluetooth switch, then open the
charging case, search for “ANC008S” click “connect”. It takes about
3-5S for the first time of the earbuds to pair.
2. Open the charging case and the earbuds will automatically connect to
the phone after the first pairing (paired device).
Warm tips: If the pairing fails, put the earbuds into the charging case,
and then try the steps above again, the earbuds will automatically shut
down when there is no devices to connect in 3 minutes.
3
Ⅳ. Charging Operation
1. Charging Case Charging:
Connect the charging cable into the charging pot on the charging case.
2. Earbuds Charging:
Put the earbuds into the charging case, the earbuds will automatically shut
down and charge itself.
Function Definition:
Function
Start/Pause
Next Song
Answer A Call
Reject A Call
End A Call
Answer the Third Call
End the Third Call
ANC/Transparency Mode Switch
Operation
Touch Right Earbud Twice Shortly
Touch left Earbud Twice Shortly
Long Touch Either Earbud
Touch Either Earbud Twice Shortly
Touch Either Earbud Twice Shortly
Touch Either Earbud Twice Shortly
Long Touch Either Earbud
Touch Either Earbud Twice Shortly
Long Touch Either Earbud
4
Indicator Light Definition:
SAFTY MATTERS:
Warning: In order to maintain the best quality of the earbuds, please wear
the earbuds correctly. Do not disassemble the hardware by yourself. Use
dry, soft cotton material to clean the earphones.
1. Do not throw the product into the fire to avoid explosion.
2. The product should avoid rain, dampness or other liquids.
3. While using the product for the first time, fully charges before using it.
4. Please use the original battery, and original charger (or wireless
charging pad).
5. Using the earbuds for the first time, please adjust the volume to
reasonably, then gently switch to the appropriate volume, if the
volume is too high, might cause tinnitus or damage to the ear and the
product itself.
5
3. Wireless Charging:
The charging case can be charged by placing it on the induction area on the
wireless charging pad.
Cancel A Call
PRODUCT STATUS
Charging Case Charging
Charging Case Charging Completed
Low Battery in Charging Case
Earbuds Charging
Earbuds Charging Completed
DESCRIPTION
Orange light ON
Orange light OFF
Orange light Flashes
Red light ON
Red light OFF