Use and Care Manual

ManualsBrandsSINKOLOGY ManualsKitchenChef Series Sisley All-in-One Undermount 18.5 in. Single Bowl Copper Bar/Prep Kitchen Sink with Pfister Faucet and Drain

Thank you for purchasing this Pster Bar Faucet. All Pster products are carefully engineered and factory tested to provide long trouble-free use under normal conditions.

This Bar Faucet is easy to install using basic tools and our easy to follow illustrated instructions. If you have any questions regarding your Bar Faucet installation, call

1-800-Pfaucet (1-800-732-8238).

1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before proceeding.

Pster recommends calling a professional if you are uncertain about install-

ing this product!

This product should be installed in accordance with all local and state plumbing and

building codes.

2 SHUT OFF WATER SUPPLY

Locate water supply inlets and shut off the water supply valves. These are usually

found under the sink or near the water meter. If you are replacing an existing

faucet, remove the faucet from the sink and clean the sink surface thoroughly.

3 TOOLS RECOMMENDED

• PTFE plumber's tape or thread sealant • Plumber's putty

• Slotted screwdriver • Pliers • Adjustable wrench

• Flashlight • Cloth

Your installation may require supply lines and/or shut-off valves, cone washers,

friction rings, or other additional tools. Consult the store where your faucet was

purchased for recommended connections that may be required for you area.

FAUCET INSTALLATION STEPS

Ensure that the Plastic Putty Plate (4A) is pressed on the Deckplate (4B). Place

a bead of plumber’s putty in the groove along the outer edge of the Putty Plate

(4A). Install the Deckplate (4B) over the holes in your sink.

5 FAUCET INSTALLATION

With the spout facing forward, carefully install the Faucet Supply Hoses (5A)

through the center hole of Deckplate (5B). Make sure that the Flats (5C) on

the Faucet Body (5D) are aligned with the Flats (5E) on the Deckplate (5B).

SINGLE POST INSTALLATION

4 INSTALLING DECKPLATE

6 INSTALLING MOUNTING RING

Place Mounting Ring (6A) over Plastic Seal (6B) and sink hole. Align Mounting

Ring (6A) to the center of sink hole.

7 FAUCET INSTALLATION

DECKPLATE INSTALLATION

Go To Step 8

STOP

ENGLISH

INSTALLATION:

Your faucet can be installed with or without the deck plate:

For installation using the deck plate:

Go To Step 4

For installation using the single post:

Go To Step 6

BOTTOM GROOVE