Installation Guide

Kitchen&BarSinks:Drop-In
Drop-in kitchen sinks are easy to install and are designed to install
beautifully in a wide range of countertop surfaces. Sinkology Drop-In
kitchen sinks make DIY kitchen renovations effortless and impactful.
Drop-In sinks can be used to replace an old sink or installed in
luxurious new countertops.
1. Flip sink upside down and trace the outside edge onto craft
paper or cardboard. Add a second line that is 1/2” inch inside
that line. Cut out the traced template using the second line.
2. Positionthetemplateatonthecountertopandalignwith
cabinet and plumbing connections.
3. Mark openings and cut the countertop.
4. Alwaysdoublecheckthesinkfortinsidetheholebefore
moving on.
5. If your sink does not come with mounting hardware, refer to
bath sink drop-in installation instructions on page 4.
6. Before dropping your new sink into the countertop for the last
time apply a thick bead of Sinkology antique brown or clear
neutral cure 100% silicone around the hole on the countertop
to form a water tight seal around the sink. See our Complete
SiliconeInstallationKit(#SINSTALL-101) for Copper Sinks.
7. Install hardware. Place
notched end of all bolts
into the keyhole slots. See
diagram. Lower the sink
carefully into the countertop
so the bolts enter without
interference.
Important
Not all Drop-In kitchen sinks require mounting hardware. If your
kitchen sink does not come with mounting brackets, we recommend
securing your sink with 100% silicone and expandable foam
(see bath sink drop-in instructions on page 4)
25
PRO
DIY