Installation Guide

Step 1. Flip sink basin upside down on countertop and mark countertop by
tracing the edge of the basin. Measure the distance between the edge
of the basin and the inside edge of the lip. Add a second line inside the
rst according to this measurement.
Step 2. Cut countertop based on the inside, second line.
Step 3. Apply silicone around hole in the underside of the countertop and
position the basin.
Step 4. Use a level to make sure that the basin is sitting ush in all directions,
while pressing down to seal.
Step 5. Clean excess silicone and mount faucet.
Step 6. Treat copper sinks with Sinkology Copper Armor for maximum
protection (apply based on directions on bottle).
KITCHEN – UNDER-MOUNT INSTALLATION