User Manual

pg. 29

7 Revision History

7.1 Revision 2.0

1) Removed Section 3 Updating the Interface Board.

2) Updated Table 1 accessibility to interface board design detail.

7.2 Revision 2.1

1) Added Revision History.

2) Section 1: Referenced Calibrated and Uncalibrated product options.

3) Figure 2: Fixed the link in footnote 3.

4) Table 1: Added I

C Sensor Output range.

5) Table 2: Corrected the addresses of the following parameters:

Delimiter – leave as 0xFF

Sensor baseline MSB

Sensor baseline LSB

Were 39, 40, & 41 respectively.

6) Section 2.3 Removed reference to I

C high speed mode. Updated detail on multiple sensor interfaces

sharing a single I

C bus

7) Section 2.4.3: Added detail on I

C Sensor Output data values.

8) Section 2.5: corrected output scale resolution from 12-bit to 10-bit and clarified operating output

values.

9) Added Section 2.6 Product Categories.

10) Figure 10: Removed Set Reference Gain control from the GUI image (the Reference Gain Setting is

automatic in the current interface board design).

7.3 Revision 2.2

1) Fixed Table 1 to show correct maximum supply voltage (12V rather than 5V as stated)