User's Manual

18
“- Check List –“
“List Start: OK”
“List Stop: OK”
“List Report: OK”
“Found 0 tags:”
“Place 1 tag in the field and run test again.”
17. Each List Test is composed of three commands given to the scanner. If
the test is successful, all these tests should say “OK” after the test name.
The application will ask you to repeat the List Test with 1) A single tag,
and 2) two tags in front of the antenna. The test is complete when the
application successfully detects two tags.
18. The Write Test requires a write - capable tag. Place the tag within 5
inches of the transmit antenna.
19. Click on the Write Test button and observe the results in the Test Results
box. If the test passes, you will see:
“- Check Write –“
“Write: OK”
20. If the test fails, follow the instructions given by the application. If you
repeatedly get the “Move tag closer to antenna” instruction, ensure
the tag is directly over the transmit antenna and there are no objects
between the antenna and tag.
21. If a second antenna pair is connected to the scanner, repeat steps
13-20 for that antenna.
22. This completes the scanner test.
DRAFT