TM SMC2040 INSTRUCTION MANUAL/ MANUAL DE INSTRUCCIONES/ MODE D’EMPLOI www.singingmachine.com The Singing Machine® is a registered trademark of The Singing Machine Co., Inc. The Singing Machine® es marca registrada de The Singing Machine Co., Inc. The Singing Machine® est une marque déposée de The Singing Machine Co., Inc.
Warnings FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
Included Please make sure that the following items are included.
Assembly Not for use with other microphone stands. Only lift unit from bottom base. Use caution when placing larger-sized devices in holder. All-in-one assembly 1 Insert the Main unit onto the Base, rotate clockwise to tighten the unit in place. 2 Lift the rubber cover on the top of the Main unit. Insert the Mic stand into the Main unit and rotate clockwise to tighten it. 3 Untighten cradle pole cap, pull up on the cradle pole. Retighten cap to keep in place.
Assembly Split type assembly v w Cradle pole v Cradle pole adjustment cap Height adjustment cap x Extendable Mic Stand u 1 Insert the Mic stand into the Base and tighten it. 2 Untighten cradle pole cap, pull up on the cradle pole. Retighten cap to keep in place. 3 Insert Cradle with Mic holders then rotate clockwise to tighten the cradle onto the mic stand. 4 Untighten height adjustment cap to adjust to a suitable height.
Location of Controls WV U u TOP v an ao ap aq ar X at ak al am w x DISPLAY REAR bm bn bo bp bq WIRELESS MIC y as bt bk bl 1. Cradle 2. Mic Holders 3. Cradle pole adjustment cap 4. Height adjustment cap 5. Speaker 6. NAVIGATION/ENTER Control 7. Rubber Cover 8. MUSIC VOLUME/MIC Volume Control 9 PLAYBACK Button 10. RECORD Button 11. VOICE EFFECTS 12. 13. 14. 15. 16. 17. 18. 19. 20. 21.
Rechargeable Battery This unit comes with a built-in rechargeable battery pack that will allow the unit to be used without being connected to AC power. The rechargeable battery pack must NOT be services/ replaced by the user. To optimize the battery life, we recommend to charge the unit once a month. When the battery indicator on the display flashes slowly, recharge the unit by following the steps below: 1 Insert the AC power cord into a conveniently located AC outlet having 120V, 60Hz.
Connections Charging the unit Insert the AC power cord into a conveniently located AC outlet having 120V AC, 60Hz. NOTES: • Make all connections prior to plugging the AC adaptor into a power outlet. • The AC adaptor has a polarized plug that fits into the AC outlet only one way. If the plug does not fit properly, turn it over and try again. Do not force and do not file or cut the wide blade. • The provided AC adapter can only be used to charge the built-in rechargeable battery.
Connections Connecting the Wireless Microphone(s) Press the / (ON/STANDBY/ LIGHTS) button to turn the unit on, the Mic indicator 1 and 2 appear in display and flash. Slide the Wireless Mic’s ON/MUTE/OFF u switch to the ON position. The Mic indicator 1 or 2 will light solid. NOTES: • Working distance of up to 30 feet/10 meters in open space. • If there is no audio input for 15 minutes, the wireless mics connection will automatically turn off.
Connections Connecting the optional wired Microphone Connect the wired microphone (not included) into Mic jack u (when desired). NOTE: Maximum of two microphones (wired or wireless) can be connected to the unit at one time. After inserting the wired microphone (Mic 3), the wireless microphone 1 (Mic 1) will be turned off automatically. u Lights Mode There are 5 built-in light modes. Repeatedly press the / button to switch between lighting effects.
Connections Connect to Wi-Fi 1 Connect the unit as described previously and ensure to connect it to a TV. Press the / (ON/ STANDBY/LIGHTS) button to turn the unit on. 2 USE YOUR MOBILE DEVICE TO CONNECT THIS UNIT Use the NAV/ENTER control to select the SINGCAST icon on your TV screen. "CAS" will display on the screen. If this unit has not been connected to your Wi-Fi network, a step 1 QR code will pop up on screen. Use your mobile device to scan the QR code allowing it a moment to load.
Connections Connect to Wi-Fi (Continued) 4 When the unit connects to your Wi-Fi successfully, "connected" will display on-screen. You can download the Singing Machine Karaoke App to listen to your favorite karaoke music and project the HD karaoke videos on your TV. 5 The unit automatically searches and pairs to a previously paired Wi-Fi network.
Connections Settings 1 Press the HOME button to go to the main menu. Using the NAV/ENTER control select the SETTINGS icon; "SEt" will appear on-screen. 2 Select Wi-Fi setting to connect or disconnect from the Wi-Fi network and check the Wi-Fi signal level. 3 Select Software update to update the software of the unit. Select Software info to check the latest software version of this unit. Factory setting 4 y 5 Select Factory setting to delete all data stored in the unit.
Operation Using SingCast Casting y U v u x 1 Connect the unit as described previously and ensure to connect it to a TV. Press the / (ON/ STANDBY/LIGHTS) button to power on the unit. 2 Use the NAV/ENTER control to select the SINGCAST icon on your TV screen; "CAS" appears on the display.
Operation Using SingCast Casting (Continued) 7 V Slide the Wireless Mic’s ON / OFF switch to the ON position. NOTE: Sliding the switch to MUTE will temporarily stop the microphone input. 8 W RECORD YOUR SINGING PERFORMANCE During music playback, press the RECORD button to record your singing and the music, "REC" will appear solid on the display. Press the RECORD button again to stop recording, "REC" will turn off. This unit is able to record for 5 minutes.
Operation Using SingCast Casting (Continued) at am ak al 10 Toggle the VOICE EFFECTS control to select a voice effect. 11 Toggle the EFFECTS STRENGTH control to select the level of the selected vocal effects. 12 Press the PERFECT PITCH button to switch between the different levels of voice pitch. Display will show level. NOTE: This function is only available for either Wireless Mic 1 or Mic 3. 13 — E15 — Press and hold the / (ON/ STANDBY/LIGHTS) button to turn off the unit.
Operation Using a Bluetooth Device 1 Connect the unit as described previously. Press the / (ON/ STANDBY/LIGHTS) button to turn the unit on. w u v w 2 WAYS TO ENTER BLUETOOTH MODE Press the /VOCALS OFF button; “bt” will start to flash on the display. 2 3 Use the NAV/ENTER control to select BLUETOOTH OPEN in the main menu; the unit should be connected to a TV. 4 The unit automatically searches and pairs a previously paired Bluetooth device (if previously paired).
Operation Using a Bluetooth Device (Continued) 5 Turn on your device’s Bluetooth option in settings to search for a discoverable device with a Bluetooth signal. Select “Singing Machine” from the device results on the Bluetooth menu. NOTE: Also refer to the user manual of your Bluetooth device for detailed instructions. 3 y U4 6 “bt” and bluetooth indicator will light solid. NOTES: • If your Bluetooth prompts you for a passcode during the pairing process, please enter “0000” to connect.
Operation Using a Bluetooth Device (Continued) 9 X Slide the Wireless Mic’s ON / OFF switch to the ON position. NOTE: Sliding the switch to MUTE will temporarily stop the microphone input. 10 at RECORD YOUR SINGING PERFORMANCE During music playback, press the RECORD button to record your singing and the music, "REC" will appear in display and light solid. Press the RECORD button again to stop recording, the "REC" will turn off. This unit is able to record for 5 minutes.
Operation Using a Bluetooth Device (Continued) 12 Toggle the VOICE EFFECTS control to select a voice effect. 13 al am an To sing without the lead singer on the recording, press the / VOCALS OFF button. To resume the lead singer, press again. NOTE: Lead vocal removal might work better on some songs than others. 14 Toggle the EFFECTS STRENGTH control to select the level of the selected vocal effects. 15 ap ao Press the PERFECT PITCH button to switch between the different levels of voice pitch.
Troubleshooting Guide Should this unit exhibit a problem, check the following before seeking service: No Power • Power is not on; Press the / button to turn power on. • The unit has no battery left. Connect to AC power to recharge the battery. • Confirm that the AC adapter is connected securely to the rear of the unit. • Connect the unit to a different outlet. • The normal function of the product may be disturbed by strong Electro-Magnetic Interference.
Need Help Casting? Start here! Scanning QR code fail • We recommend for you to scan the QR Code once more. If you cannot scan it successfully, you may need to try a specific QR code scanning APP to help. • Alternatively, you can go into "SETTINGS menu/Wi-Fi setting" to connect the SingCast unit to your Wi-Fi network directly. No Internet connection • Ensure the unit is in SingCast mode. • Ensure the input Wi-Fi password is correct.
Specifications AUDIO Output Power...................................................................................................................70 Watts (RMS) BLUETOOTH Bluetooth Version..................................................................................................................................V5.0 Working Distance............................................. Up to 30 feet/10 meters measured in open space Wi-Fi Wi-Fi frequency ........................................................
Advertencias PRECAUCIÓN RIESGO DE DESCARGA ELÉCTRICA NO ABRIR PRECAUCIÓN: PARA REDUCIR EL RIESGO DE DESCARGAS ELÉCTRICAS, NO QUITE LA CUBIERTA (NI LA TAPA POSTERIOR). NO HAY PIEZAS REPARABLES POR EL USUARIO ADENTRO. DERIVE LAS REPARACIONES A PERSONAL DE SERVICIO CALIFICADO.
Piezas incluidas Asegúrese de que estén incluidos las siguientes piezas.
Ensamblaje No debe usarse con otros soportes de micrófono. Levante la unidad únicamente desde la base inferior. Tenga cuidado al colocar dispositivos de mayor tamaño en el soporte. Ensamblaje todo en uno 1 Inserte la unidad principal en la base, gírela en el sentido de las agujas del reloj para apretar la unidad en su lugar. 2 Levanta la cubierta de goma en la parte superior de la unidad principal.
Ensamblaje Montaje tipo split w v 1 Inserte el soporte de micrófono en la base y apriételo. 2 Afloje la tapa del poste de la cuna, levante el poste hacia arriba. Vuelva a apretar la tapa para mantener en su lugar. 3 Inserte la base con los soportes del micrófono y luego gire en el sentido de las agujas del reloj para apretar la base en el soporte del micrófono. 4 Inserte y luego gire para apretar la cuna con soportes para micrófono en el poste.
