Instructions / Assembly

10
clEANINg
SINGER recommends cleaning your garment steamer at least once a week.
Remove the Water Tank by pulling upward on the handle.
Turn the switch to “Off” and unplug the garment steamer. •
Allow the garment steamer to cool for at least 30 minutes.•
Remove the Cool Touch Hose. Collapse and remove the Telescopic Pole. •
Remove and drain the Water Tank. Rinse it with fresh water and let it drain •
completely. Place it back on the Water Reservoir.
Drain the water tank by removing the Drain Plug and emptying the contents. •
Flush the unit by filling the Water Reservoir and the Hose Connector with •
fresh water and draining completely. Replace the Drain Plug.
Wrap the hose around the Telescopic Pole once, placing the Steam Head on •
the Steam Head Hanger to store.
Removing Mineral Build-Up
It is common for minerals found in hard water to build up inside the steamer,
causing intermittent or weak steam. Depending on your water quality, SINGER
recommends removing the mineral build-up after the first 1 to 2 weeks of using
this steamer. If you do not use de-mineralized or distilled water in your steamer,
follow these steps monthly.
Turn the switch to “Off” and unplug the steamer. •
Remove the Cool Touch Hose. Collapse and remove the Telescopic Pole. •
Drain the Water Reservoir, and empty the water from the Water Tank. •
Prepare a solution of 1 cup vinegar and 1 cup water. •
Slowly pour the solution into the Hose Connector until the Water Reservoir is •
about half full, near the top of the hose.
Let the solution stand for about 40 minutes.•
Drain the solution by removing the Drain Plug and emptying the solution into a •
sink or tub.
Drain the solution from the Hose Connector by tilting the unit over a sink or tub •
and pouring the water out.
Pour clean water into the Hose Connector and Water Reservoir inlet and drain. •
Repeat this step until the vinegar odor dissipates.
Reassemble the unit. •