Operation Manual

4
USE
-
Never iron over zips, rivets in jeans, etc. These will damage the soleplate. Ir
on around
any such objects.
-
The steam generator’s holder for the ir
on will become hot. Do not touch it whilst you
are ironing.
- Never point the soleplate at persons during use, steam is very hot.
-
Check whether ironing-instruction labels ar
e attached to clothing. Always observe any
such instructions.
-
The filling aperture of the water r
eservoir must not be opened during use.
-
Do not remove the Calc Clean descaling cap fr
om the body of the generator at any
time. Behind the cap is a water outlet which connects directly to the steam generator
and it is very hot during use!
DRY IRONING
1. Fill the water reservoir.
2. Put the iron on the steam generator’s holder.
3. Put the plug in the wall socket.
4. Turn on the ON/OFF switch and turn the iron’s temperature-control dial (No.2) to adjust
the temperature to the required setting. The iron starts heating.
5. Adjust the temperature in accordance with the directions given in table 1.
6. When the indicator light on the iron turns off, the temperature is reached. You now can
start ironing.
STEAM IRONING
1.
Fill the water reservoir
.
2.
Put the iron on the steam generator’
s holder.
3.
Put the plug in the wall socket.
4. Make sure that ther
e is enough water in the reservoir.
5.
Set the on/off switch steam generator to ‘I’. The steam generator starts to pump the
water and heat it. The indicator light “steam r
eady” illuminates when steam is ready.
6.
Meanwhile adjust the temperature by tur
ning the iron’s temperature-control dial to
the required setting. Adjust the temperature in accordance with the directions given
in table 1.
The fabric may not be ironed.
Synthetic
- Acryl
- Modacrylic
- Polypropylene
- Polyurethane
- Acetate
- Triacetate
SilkSilk
- Metal
- Cupro
- Polyester
- Modal
- Viscose
- Polyamide (nylon)
Synthetic
Synthetic
W
ool - Wool
Cotton - Cotton
Linen - Linen
Label Type of Fabric Material Temperatur
e
Table 1