User's Manual

Chapter 2. Installing and Set Up
2-11
2. Set Outer Box(Bottom), Cushion (Bottom Rear) and
Cushion(Bottom Middle and put Slide Base on the
concave parts of Cushion(Bottom Middle).
3. Set slope cardboard on the Outer Box(Bottom).
4. Hold right side of printer and handgrip of left side, and
hold up the printer on rails of slope material. Slide the
printer on rails slowly, and hold up the printer on cushion
(Bottom Middle).
5. Push the printer until Cushion (Bottom Rear) firmly.
Caution: The weight of this printer is around 70Kg.
Be careful to handle it., And be sure to hold
handgrip.
Caution: Pay attention to the direction of Slide
Base.
Slide Base
（chamfered side）
Outer Box
（Bottom）
Cushion
（
Bottom
Center
）
Cushion
(Bottom Rear）
Caution:
Impress Stopper Parts of Slope
Cardboard to Cushion (Middle).
Slope Cardboard
Rails
Cushion
(Bottom Rear）