User's Manual

- 4 -

PROGRAM OF TRANSMITTERS

a. Turn ignition on and open a door first and then press Valet/Override switch 4 times (within 15

seconds), then LED will be on continuously and siren will emit 1 long chirp. You are now in the

stage of programming mode.

b. Press # 1 button then siren will emit 2 short chirps 4 times.

c. Turn ignition off. LED will be off and siren will emit 4 chirps. You are now in stage of exiting

programming mode.

d. You can repeat this and have maximum 4 programmed transmitters per module. If you program

new transmitter, we recommend to delete old code memory and to re-program all existing

transmitters. You can have this job up to 4 times by same way above.

ACTIVATION OF ARMING

a. Exit the vehicle and close all entrances.

b. Press # 1 button at once.

c. Siren chirps 1 time, light flashes 1 time and LED flashes slowly every sec.

d. All protected entrances are armed.

e. Starter kill enableÆ Starter disables relay which is activated and prevents the engine cranking.

f. If any entrance is opened, siren chirps 3 times and LED flashes rapidly for notification. When

door is closed, the arming will start.

g. After 3 seconds of arming, alarm system will be activated. Shock sensor will not be activated

during 3 seconds. It will be re-activated in more than 3 seconds and the sensor becomes stable.

ACTIVATION OF DISARMING

a. Press #2 button at once.

b. Siren chirps 2 times, light flashes 2 times and LED off.

c. All protected securities will be disarmed.

d. Starter kill disableÆ Start motor can be enabled

e. Memory of intrusion: If siren chirps and light flashes 4 times when you disarm the alarm, this

notifies alarm has been triggered. Rapid LED flash every 2 times notifies electric security has been

triggered, while every 3 times LED flash notifies door had been triggered.

MUTE ARMING/ DISARMING

a. Press # 3 one time, then press # 1 one time within 3 seconds to enter Mute Arming.

b. Press # 3 one time, then press # 2 one time within 3 seconds to enter Mute disarming

DEACTIVATION OF EMERGENCY

If transmitter is lost or damaged when alarm system is activated arming,

following process is needed .

Æ Enter Valet Mode first

ACC

OFF

START

VALET SW -8 -TI MES

Open a Door