Specifications

Section 3 — Installation
!
The DAI-2 Dial-up Audio Interface should be installed only by qualified technical personnel. An attempt to
install this device by a person who is not technically qualified could result in a hazardous condition to the
installer or other personnel, and/or damage to the DAI-2 or other equipment. Broadcast equipment can
operate at voltages that are potentially lethal. Please ensure that proper safety precautions have been
made before installing this device.
3.1 System Includes
The DAI-2 Dial-up Audio Interface package contains these items:
Dial-up Audio Interface model DAI-2
rack mounted chassis and relay panel
ribbon cable with two connectors
12 VDC wall plug supply
modular telephone cable
operation manual
All systems are fully tested before leaving the factory but damage may occur in transport. When the DAI-2 is
unpacked, it should be inspected for obvious signs of mechanical damage or loose parts. Loose parts should be
tightened before installation. If damage is found, save the packing material and report it to the shipping company and
the dealer from which it was purchased. Do not install the system.
3.2 Installing the System
The DAI-2 is easy to install if you are careful, patient and alert. Installation is broken down into a series of logical
steps but you should have some previous engineering experience in a broadcast environment before attempting to
install the DAI-2. Access to the building does not necessarily qualify you as an engineer. We cannot protect you
from yourself, but we want to make this point very clearly: if you are unfamiliar with this type of equipment, please
contact a properly qualified engineer to handle installation and setup of this system.
DAI-2 Installation page 3. 1