Specifications

5.5 System Profile Settings

The following commands are used in the System Profile listing at the end of this section.

5.5.1 Command Set

A command set defines how the DAI-2 will respond to DTMF tones during operation. The DAI-2 stores four command

sets in memory but only one is active at a time. The active command set is programmed at address 358.

Value Active Command Set

0 User Programmable Command Set (factory setting)

1 Pre-programmed Set 1--Soundbite Recorder

2 Pre-programmed Set 2--Remote Broadcast

3 Pre-programmed Set 3--Emergency Operation

+ Values of 4 or more default to 3

5.5.2 Safeguard Timer

The DAI-2 has a safeguard timer to keep the DAI-2 from staying on-line at a remote location indefinitely. If the unit is

on-line and has not received a key or logic level command for the programmed length of time, it will hang up the line

and reset to power up conditions. The timer can be disabled by programming a value of 10. The safeguard timer is

programmed at address 357.

Value Time Out Length

0 5 minutes

1 8 minutes

2 17 minutes

3 32 minutes

4 53 minutes

5 1 hour, 20 minutes (factory setting)

6 1 hour, 53 minutes

7 2 hours, 32 minutes

8 3 hours, 17 minutes

9 4 hours, 8 minutes

10 Disabled

5.5.3 Security Codes

There are two programmable security codes in the DAI-2. Each can be up to eight digits in length. Unused digits

should be programmed to 10 using the "*" key to program a 10. The Main Security Code is used to gain access to the

system and is requested any time the unit answers the phone. It is factory programmed as "12345678" at address

316 through 323. The Programming Security Code is requested when there is an attempt to enter the programming

mode of the DAI-2. It is factory programmed to "1266"--the final four digits are 10's so they are ignored--at addresses

324 through 331. While this is not generally recommended, a security code can be entirely disabled by programming

all digits to 10.

Value Security Code

0-9 Required digit in security code

10 Unused digit in security code

DAI-2 Programming page 5. 9