Specifications

Section 5 – Programming
5.1 Overview 5.1
5.2 Introduction to the Command Matrix 5.1
5.3 Programming Mode 5.2
Programming Mode Basics 5.2
Read from Memory 5.3
Write to Memory 5.4
Telephone Numbers 5.4
Alarm System 5.5
Programming Suggestions 5.5
Programming Example 5.6
5.4 Command Matrix 5.7
Command Matrix Settings 5.8
5.5 System Profile Settings 5.9
Command Set 5.9
Safeguard Timer 5.9
Security Codes 5.9
Logic-Level Inputs 5.10
Telephone Numbers 5.11
Automatic Level Control (ALC) 5.11
Ring Number 5.12
DTMF Hold Time 5.13
Identification Tones 5.13
Slate Tone 5.14
Delay Unit 5.14
Leased Line Mode 5.14
5.6 Memory Address List 5.15
5.7 Factory Command Matrix Programming 5.24
Section 6 – Troubleshooting and Repair
6.1 Common Problems and Possible Solutions 6.1
6.2 Factory Service Policy 6.2
6.3 Repair Procedure 6.3
Section 7 – Specifications
7.1 Electrical & Mechanical Specifications 7.1
7.2 Flat Cable Pinout 7.1
7.3 Schematic Diagrams 7.2
7.4 Component Layouts 7.3
7.5 Parts List 7.5
DAI-2 Table of Contents ii