Specifications
These items are common to both the read and write programming modes:
• in programming mode, the # key acts like an enter key
• in programming mode, one long tone is a prompt for you to enter something
• in programming mode, two short beeps is an ‘OK’ response
• in programming mode, one long low tone means that an error has occurred
• the programming security code is: 1266
The DAI-2 will only prompt for the programming security code one time per call. If you exit programming mode and
enter again during the same call, you will hear the confirmation beeps instead of the prompt tone.
5.3.2 Read from Memory
Read mode is used to verify system settings without making changes.
• invoke the programming read mode by pressing ❊ -7
• the DAI-2 responds with one long tone to prompt for the programming security code
• enter the programming security code: 1266
• the DAI-2 responds with two short beeps to confirm that it is in programming read mode
After the programming security code is correctly entered, the DAI-2 waits for an address. The address identifies
what data should be retrieved by where it resides in memory. To determine the address, locate the description of the
data you would like to read in the command matrix or the system profile. Each space in the command matrix has a
three digit number printed along its edge. In the system profile, each item has a three digit number that is the
address. Leading zeros are significant so all three digits of the address are required. The DAI-2 will reply with two
short beeps to acknowledge a valid address.
• enter the three digit address for the data you want to read
• press # to read the data from that memory address
• the DAI-2 responds with a number of short beeps equal to the value stored at the address
The value zero will produce one long tone instead of zero beeps. Pressing a key while the DAI-2 is beeping will
silence it whether it is finished with the reply or not.
The DAI-2 automatically increments the address one location after it reads the data. If you press the # key again, the
DAI-2 will read the data from the next address and so on. It is possible to increment through all addresses this way.
After pressing # to read data:
• press # again to read the value at the next consecutive address , or
• enter aaato jump to a new address--aaa, or
• enter ❊ -❊ to exit the programming mode
DAI-2 Programming page 5. 3