Specifications

4.5.3 Command Set 2 -- Remote Broadcaster
Command Set 2 is factory programmed as a control unit for remote broadcasts. In this configuration the DAI-2 is
used to start cart machines and switch audio while the air personality is at a remote site. A suggested connection
diagram is given in the Installation section of this manual to operate the DAI-2 with this command set.
Establish a connection to the DAI-2, enter the appropriate security code to access the operating mode. The keypad
functions for this command set are defined as follows:
AUX
3
*
#
AIR
AUX
1
AUX
2
1 2 3
4
Start Source 1
Start Source 2
Start Source 3
Start Source 4 Start Aux 2
Start Aux 3 Stop All!
On AIR
Off AIR
(monitor)
Blank buttons
are not used
Start Aux 1
8
Figure 4.5; Keypad assignments for remote broadcaster
Press DAI-2 Response
1 Start Cart Machine 1
2 Start Cart Machine 2
3 Start Cart Machine 3
4 Start Cart Machine 4
5 Start Auxiliary Device 1
6 Start Auxiliary Device 2
7 Start Auxiliary Device 3
8 unused
9 Stop All!--reset cart machines to idle condition
0 OFF AIR--monitor air signal
# ON AIR--send telephone audio on air
unused
LL1 ON AIR--send telephone audio on air
LL2 Start Auxiliary Device 1
LL3 Start Auxiliary Device 2
LL4 Start Auxiliary Device 3
All start buttons switch audio into monitor mode. The STOP key resets all start buttons but leaves audio in the
selected mode. The Off-AIR key resets all start buttons and switches audio to the monitor mode. On-AIR is the only
key that makes the telephone audio live.
DAI-2 Operation page 4. 7