Instructions

2-49
UI Menu Function
2
Menu Description Value
Active Leveling This function executes Bed leveling before printing
starts and offset the bed leveling by moving the bed
in the direction the Z-axis during the printing.
On, Off
Lamp Menu to configure settings for machine lamp.
Note
- Lamp will be activated as connecting the Web
Monitor
Always On,
On only in Printing, Always Off,
Power Saving The volume level of beep sound can be adjusted
using this menu.
0 ~ 100 Min
0 Min : Do not use Power Saving Mode.
5~100Min : Power Saving Mode in
5~100Min. of Inactivity.
Beep Settings for the units of measurments displayed on
the printer.
Off, Low, Middle, High
Unit This menu enables you to configure the sound of
Voice Guide in the machine.
Temp : ˚C, ˚F
Length : m, feet
Voice Guide This menu enables you to configure the sound of
Voice Guide in the machine.
Speech : On, Off
Volume : Lower, Low, Normal, High,
Highest
Speed : Very Slow, Slow, Normal, Fast,
Very Fast
Language Menu to set language for machine. English, 한국어, 中文,
Español, Français, 日本語, Deutsch
Time Setting You can view or change the time setting. Refer to “Time Setting” section
Time Zone You can view or change the time zone setting. Refer to “Time Zone” section
E-mail The printer takes an image of the current printing
status and sends the information to the email
address specified.
Printer will send information of completion (%)
based on the PC program standard settings.
Maximum of 10 emails can be sent.
Refer to “E-Mail” section
Security This menu enables you to set up the Security menu
whether to use the 3D printer or not.
On, Off
Camera Frame
Rate Setting
You can set the frame rate of the web monitor
camera.
1 ~ 5 fps
*SSD Format Format the machine's storage memory. Start
* Included only on 7X model.