Instructions

UI Menu Function
2-44
2
4 Check the pop-up notice and press the [OK] button.
Caution
- Improper usage of a third-party filament may cause device failure and poor printing quality.
Therefore, it is important to create a correct gcode and apply it to a device by fully understanding
the characteristics of a third-party filament, including the recommended printing temperature and speed.
- As soft filament with shore hardness of 65 D or less (TPU, TPE, etc.) may cause transfer problem, it is
not applicable. (TPE is not available for the 5X model, but it needs to be directly inserted into a nozzle
after opening the top door for the 7X model.)
A filament containing abrasive additives (metal component, carbon fiber) may cause transfer problem
and reduce the service life of nozzles. (Wear-resistance nozzles are optional.)
- If a third-party filament has a too large spool, it would not be usable with it inserted.
Make sure that the spool to be used has the width of 95 mm or less and an outer diameter of 265 mm
or less.
- When 3rd Party Filament gets all consumed, the filament end sometimes gets stuck in the machine and
this tends to cause the filament feeding problem (Notification 401). If Notification 401 occurs, in order to
continue printing, please load new filament spool after unloading the left-over filament previously used
in the machine.
5 [Spool] will be displayed on top of the screen.