Instructions

Before using the Machine
12
8. Notices
 ❖
Noise Emission Level
   ThefollowingaremeasuredinaccordanceofISO7779andreportedtomeetISO9296.
Some modes may not be available in your purchased products.
Average Sound Pressure at 1 Meter Away
Printing 55dBA(NormalPrintCondition-Printingspeed40mm/s,Travelspeed130mm/s)
Standby under40dBA
❖
Temperature/Humidity
Operation 16 °C ~ 29 °C 20%RH~70%RH
Storage -30°C~40°C,15%RH~85%RH(Nocondensation,mustnottouchthefloor)
❖
Disposal of The Products
Do not dispose the machine and consumables together with household wastes.
For disposal or recycling, contact your local sales office.
❖
EMI(Electromagnetic Interference) Notice
This machine complies with the limits for Class A.
ClassA(IndustrialDevice):ThisisaclassAproduct.Inadomesticenvironmentthisproductmaycauseradio
interference in which case the user may be required to take adequate measures.
FCC COMPLIANCE STATEMET
    Thisdevicecomplieswithpart15oftheFCCRules.Operationissubjecttothefollowingtwoconditions:
    (1)Thisdevicemaynotcauseharmfulinterference,and(2)thisdevicemustacceptanyinterference
received, Including interference that may cause undesired operation.
INFORMATION TO USER
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
    userisencouragedtotrytocorrecttheinterferencebyonemoreofthefollowingmeasures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Any changes or modifications not expressly approved by the manufacturer responsible for compliance
could void the user’s authority to operate the equipment.
DECLARATION OF CONFORMITY (DOC Letter): 12page
❖
Wireless LAN Specifications
The wireless device may be affected by electromagnetic interference so it should not be used for life
saving services.