Instructions

Before using the Machine
10
6. Instructions for Use
Caution
- The nozzle and the bed that are inside the machine are very hot during machine operation.
Please be cautious not to touch the nozzle or the bed during removal of the printed objected or during
inspection of the machine inside. It may become the cause of injuries or burns.
- Never operate the machine in the way this manual does not specifically instruct.
Notification for California customers, USA
Warning
- This product uses chemicals known to the State of California to cause cancer and birth defects or other
reproductive harm. This appliance and its accessories can cause low-level exposure to chemicals
during operation, which can be reduced by operating the appliance in a well ventilated area.
Caution
- Do not open the side cover or touch any parts of the extruder unit during machine operation to prevent
personal injuries of damages.
- If you need inspection of the extruder unit, turn off the power and disconnect the power cord and follow
the instructions below.
Openthesidedoor.
Removing filaments in the path
Remove 5 screws.
Remove 2 covers
Make sure that there are no missing parts
during filament removal, then reassemble
* If the brass bushing comes out of the cover,
insert the bushing as shown in the right figure
and then assemble the cover.
If the filament is clogged in the extruder while using the device, follow the instructions below.
① ②
③ ④
Removing filaments in the path