Instructions

9
Before using the Machine
5.3 Flexible
When using flexible materials, clean the inside of the nozzle after the filament load. Even if the inside of the nozzle is
cleaned,iftheinsideofthenozzlehasdebris,thenozzlemaybecloggedorthefilamentmaybetransported.(Refer
toP.5-3“1.5CleaningtheInsideoftheNozzle”.)
Be careful because it is difficult to set the output condition compared with PLA and ABS materials. Warp or spider
web may occur at output.
Flexiblematerialscancausetwistsintheextruderorinsidethecartridgerollers.(RefertoP.5-16“3.3Solutionfor
Notification401”.)
Nozzle temperature: 235 ° C
Bed temperature: 60 ° C
Recommended direction of the bed : Side A
Color: white, red, yellow, green, black, orange
Storage: Store in cartridges with the silica gel that was included in the purchase.
5.4 PVA, PVA+
PVA is a water-soluble support material. PVA can be used with PLA and it can be removed from the print by
dissolvingitunderthewater(refertoP.4-4“1.2PVAFilamentRemovalGuide”).
This material is very sensitive to moisture, so it should only be used in environments with humidity below 50%.
Becarefulwhenusinginahumidenvironmentbecauseitmaycauseproblemsinfilamenttransport(refertoP.5-16
“3.5SolutionforNotification401”.).
Carbonization may occur inside the nozzle during long hour printing. Please periodically clean the inside of the nozzle
(refertoP.5-3“1.5CleaningtheinsideoftheNozzle”).
Storage:Whennotinuse,putthePVAfilamentandsilicagelinthezipperbagthatwasincludedinthepurchase,
and keep it away from outside air. If the PVA filament is already exposed to moisture for a long time, it
shouldbestoredfor48hoursormorewithsilicagelinasealedcontainer.
Nozzle temperature:215°C(PVA),200°C(PVA+),
Bed temperature:55°C
Recommended direction of the bed : Side A
Important
- Please note that you shall follow our technical information or support in this manual at your own discretion
and risk.
We are not responsible for the use and handling of PVA filaments other than those described in this manual.
PVA filament specifications can be changed without any notice.