Instructions

5-15
Maintenance
5
3. Problems and Solutions
3.1 In Cases where Filament is Cut Between the Extruder and Nozzle
1 Remove the snap ring from the fitting of the nozzle part and then the tube.
󱈾 Move the filament toward the nozzle to push out the broken part in the extruder operation mode.
󱈾Remove all broken parts, install the nozzle to the tube, and install the snap ring.
※Push in the tube until the black section of it is fully inserted.
After installing the snap ring, push in the tube slightly more (by 1.5 mm).
󱈾Transfer the filament toward the nozzle and make sure that it comes out of the nozzle in the extruder
operation mode.
3.2 When Filament End is Visible Outside the Cartridge After Unloading
1 Pull out the filament approximately 50~60cm, and cut the filament.
Note
-
Cutting Filament Tip
󱇱
Cut the filament in the way the cut end is sharp as shown below. It makes the filament run through easier.
2 Like the image below turn the gears and the filament will retrieve back to cartridge. Insert until filament is
invisible, reinstall the cartridge into the printer and activate LOAD.