Instructions
Table Of Contents
- 3DWOX 5x/7x/ USER MANUAL
- Safety Instructions
- Before use
- Prohibition and limitation
- Contents
- Before using the Machine
- Chapter 1 Preparations forMachine Operation
- Chapter 2 UI Menu Function
- Chapter 3 Printing
- Chapter 4 Printed Output Check
- Chapter 5 Maintenance
- Chapter 6 Appendix
- Notice to Users
5-9
Maintenance
5
12
Repeat from step 3 until the filaments are free of contaminants as shown below.
If cleaned filament comes out with no contaminants as shown in the figure on the left below, the nozzle cleaning
is complete.
Cleaned Filament Contaminated Filament
13
Assemble the tube and the snap ring in reverse order from step 3 to step 1, and then turn the lever to its original
position.
Caution
-
Make sure to place the lever to its original position since this may affect the print quality.
14
Check whether the filament is extruded properly from the [Setting]-[Extruder] menu.
Note
-
Refer to P.2-19 “Extruder” for the details.
❖
USING NOZZLE CLEAN TOOL
If the filament does not come out of the nozzle well in step 5, proceed as follows.
Once you have completed the steps below, proceed to step 5 again.
❖ Using Nozzle Spring Pin
If the filament does not come out of the nozzle even though the nozzle cleaner is used, use the nozzle spring pin to
drill the nozzle inlet.