Instructions
Table Of Contents
- 3DWOX 5x/7x/ USER MANUAL
- Safety Instructions
- Before use
- Prohibition and limitation
- Contents
- Before using the Machine
- Chapter 1 Preparations forMachine Operation
- Chapter 2 UI Menu Function
- Chapter 3 Printing
- Chapter 4 Printed Output Check
- Chapter 5 Maintenance
- Chapter 6 Appendix
- Notice to Users
Maintenance
5-8
5
9 Remove the nozzle cleaning tool and reassemble the nozzle. Assemble the nozzle and then press the [Connect]
button in the UI to reconnect it.
Once connected, heat the nozzle again, as explained in Step 6.
1
10
Press the home button in the UI to lower the temperature of the nozzle. Slowly push the PLA filament until the
nozzle temperature is 180 °C
11
If the nozzle temperature is between 80 ~ 90 ° C, remove the tube and pull out the PLA filament.
(If the PLA filament is disconnected inside, retry extruder mode and repeat the each procedure from step 5.)