Instructions
Table Of Contents
- 3DWOX 5x/7x/ USER MANUAL
- Safety Instructions
- Before use
- Prohibition and limitation
- Contents
- Before using the Machine
- Chapter 1 Preparations forMachine Operation
- Chapter 2 UI Menu Function
- Chapter 3 Printing
- Chapter 4 Printed Output Check
- Chapter 5 Maintenance
- Chapter 6 Appendix
- Notice to Users
4-5
Printed Output Check
4
Nozzle
Bed
Z-offset
calibration sheet
Z-offset
calibration sheet
-
When ABS materials are output
-
If outputs are not properly attached to Side B, use only Side A, or carry out printing by adding the raft
setting at the slicer.
-
When one or more arranged small outputs (50 mm × 50 mm or smaller) that have a small area at which
they attach to the bed are printed out, it is recommended to print by adding the raft setting to Side A.
4 Correcting Output Model
Output quality may vary depending on the shapes of the output model. To get the optimal quality, carry out
printing by changing the shape or output direction of the model or by adjusting the output condition at the slicer.
5 Recommended Direction of the Bed
Material PLA ABS FLEX PVA(PVA+)
Direction Side A Side A or Side B Side A Side A