Instructions
Table Of Contents
- 3DWOX 5x/7x/ USER MANUAL
- Safety Instructions
- Before use
- Prohibition and limitation
- Contents
- Before using the Machine
- Chapter 1 Preparations forMachine Operation
- Chapter 2 UI Menu Function
- Chapter 3 Printing
- Chapter 4 Printed Output Check
- Chapter 5 Maintenance
- Chapter 6 Appendix
- Notice to Users
4-3
Printed Output Check
4
Detach the object from the Flexible Bed. The object can be easily detached by bending the Flexible Bed up and
down. Using the scrapper provided with the printer will be useful.
Be careful not to apply too much pressure while using the scrapper could damage the bed sheet and the bed.
Depending on the filament material the printed output may easily break or damage, please be cautious.
4 Flexible Bed Installation
①After facing upwards the side to be used between side A or B of the bed sheet, push the Flexible Bed all the
way in as shown in the picture.
②Place Flexible Bed fix to position.
③ If the flexible bed is placed at an angle, it may be difficult to level the bed. Place it down to match the base.
Caution
-
Any foreign substance left on a surface of the bed can cause a problem in printing.
Make sure there is nothing left on the bed before usage.