Instructions

Table Of Contents

Printed Output Check

4-2

1. Printed Output Check

1.1 Detaching Printed Output

Note

If Side B of the FLEXIBLE bed is used, the Printed Output can be detached when the bed cooled down, without

detaching the FLEXIBLE bed.

If Printed Output is large that doesn’t detached on its own, detach the flexible bed after the bed has cooled down,

and detach the Printed Output by bending the bed up and down. (Scraper is not required).

To safely detach the printed model, first let the bed cool down. Bed top plates must be detached as well.

Caution

Hot Surface

Without sufficient cooling the bed can be very hot. Please be cautious coming into contact .

It may cause burns.

Caution

Heavy Risk

When you detach the bed it may fall and cause injury. Please detach the bed carefully to prevent

it from dropping.

1 Cooling the Bed

After the printer has finished printing, check the LCD screen and built-in speaker. Wait until temperature goes

below 40ºC or 104ºF. Do not touch the bed or the bed handle until you are told you can touch the bed.

Caution

Do not touch the output until the bed is cooled down.

To remove the output before the bed is cooled down, press the [Cancel] button and wear protective gear

and remove.

2 Detaching Bed

The Flexible Bed is detached if you hold the bed handle and lift it.

3 Detaching the printed output

Caution

Risk of Injuries

The scrapper is very sharp. Handle with care.

Please be cautious of inuries when removing printed objects with the scrapper.

When you have printed the large object, be careful when removing the bed so that the object

does not touch the interior of the printer.