Technical data

- Setting the speed

To adapt the Bravo® Stripper to different flooring, adjust the speed. The optimum

speed depends on the type of flooring, the adhesive and the ambient temperature.

Therefore, generally valid statements cannot be given.

Note: if the blade jumps on top of the flooring, reduce the speed.

5.3 Adjusting the angle of the blade

The angle of the blade can be adjusted in 3 positions.

- Remove screw (1) at both sides of the machine

- Adjust the angle and tighten the screws in the

- appropriate thread

Optimum angle of the blade

The optimum angle of the blade depends on the type of flooring, the adhesive and the

subfloor. Due to the variety of working conditions generally valid statements cannot be

given.

Note: if the blade jumps on top of the flooring, set the angle steeper. Set the angle flat

with soft subfloors like particleboards or wood. Otherwise you might deteriorate the

subfloor.

- Adjusting the handle

You can adjust the handle in many different ways.

a. The upper bar of the handle can be moved sideways. This allows you to work

along walls. To adjust the handle, loosen the thumb screw on top of the handle

and move the bar sideways.

b. The inclination of the handle can be adjusted to adapt the machine to the

stature of the operator.

To adjust the inclination, loosen the thumb screw at the foot of the handle.

Note: after changing the inclination of the handle, it may be necessary to readjust the

handle attachment of the clutch. The clutch lever at the motor housing must always be

moveable to both end positions. If not:

- loosen the thumb screw of the handle attachment of the clutch

- move the attachment up or down