Technical data

- Maintenance
The Bravo® Stripper is virtually maintenance free.
Check brushes periodically to prevent damage to armature.
Changing the blade
Disconnect the power supply before changing the blade. Use work gloves for
your own safety.
- Put on the blade protection (enclosed in the tools set)
Warning! Very sharp blade! You may cause injury without using the blade
protection!
- Clean and loosen the screws of the blade mounting.
Attention! Set the wrench at a position opposite to the blade to avoid injury.
- Replace the blade.
Make sure that the sharp bevel of the blade always faces upwards and the blade
fits in exactly the position of the old one.
5.0 Use
Assembling the machine
Mount the handle with the thumb screw to the housing. To assemble the clutch,
just press the socket joint onto the clutch lever at the machine housing.
For your safety the Bravo® Stripper comes with the blade not mounted. Make sure
that the power supply is disconnected before mounting the blade. The sharp bevel of the
blade must always face up and the blade must sit close to its support.
See also Chapter 4.0 Maintenance, “Changing the blade”.
Operation panel
Operate the Bravo Stripper at the operating
panel on top of the handle assy.
- switch (1) actuates the blade movement
- switch (2) actuates the motor drive
- knob (3) controls the speed in the
range of 5 to 20 m/min
In operation, engage the motor drive with
the hand clutch, and not with switch (2)
Starting
4
The Bravo® Stripper is equipped with 2 operating switches located at the operating
panel.