Service manual

74
4 DISASSEMBLY AND ASSEMBLY PROCEDURE OF MAIN PARTS
4�1 Outdoor Unit
Side Discharge Indoor Unit
Assembly and Disassembly of the Compressor
Remarks: Prior to the assembly of the compressor, make sure there is no refrigerant in the pipeline and the power supply is cut off.
Steps Illustrations Operation Instructions
1.Remove the power
cords away
Label the color of the
power cords and the
code of the terminals
●Loosen the screws used to x the
power cord with a screw driver.
●Pull out the power cord.
Note: when removing the power
cord, please label the power
cord and the terminals to avoid
misconnecting next time.
2.Loosen the screws used to
x the base of the compressor
Tighten the screws on
the base of the new
compressor by a wrench.
●Loosen the screws on the base of
the compressor with a wrench.
3.Separate the compressor
with the connecting pipe
Disconnect the pipeline
connected with the
compressorthrough the
welding gun.
● Burn the joint of the connecting
pipe of the compressor.
●Pull out the connecting pipe.
Note: neverr let the ame
contact any other componnet.
4.Remove the compressor
away from the seating.
Remove the damaged
compressor out.
●Remove and replace the compressor
Note: never let the ame
touch any other component
during the replacement.
5.Fix the new compressor
on the seating.
Tighten the screws on
the base of the new
compressor by a wrench.
● Tighten the screws on the
seating of the new compressor
72